Factory Calibration
Our calibration laboratory offers factory calibrations for all types of flow meters, as well as for the measured variables of pressure, temperature and humidity. We can provide you with factory calibrations both at our calibration laboratory as well as at your own premises.
The calibrations are subject to the recalibration and traceability requirements of DIN EN ISO 9001 and always ensue from a comparison with measuring equipment which has been regularly recalibrated in an accredited DAkkS calibration laboratory or at the Federal Institute of Technical Physics (PTB).
Our range of services at factory calibration:
| Measurement Quantity | Measurement Range | Calibration Standard | Trace- ability |
|---|---|---|---|
| Leackage (Air) Volume Flow (Air) On-site Mass Flow (Air) On-site | 0,6 ml/h up to 60 ml/h 60 ml/h up to 10.000 m3/h 60 ml/h up to 4.700 m3/h 72 mg/h up to 12.000 kg/h 72 mg/h up to 5.640 kg/h | PVTt procedure Crit. nozzles, gas meter, LFE Gas meter, LFE Crit. nozzles, gas meter, LFE Gas meter, LFE | DAkkS |
| Flow Generation In house (Air) On-Site (Air) | bis 100 Nm3/h compressed air (8 bar) up to 500 / 2000 / 10.000 m3/h vacuum (-600 / -300 / -80 mbar) Medium supply must be provided by customer. | ||
| Absolute pressure | 0 up to 70 bara | Piston manometer, El. pressure sensor | DAkkS |
| Positive pressure Negative pressure | 0 up to 70 bar 0 up to -1 bar | Piston manometer, El. pressure sensor | DAkkS |
| Temperature | 0 up to 90 °C | Resistance thermometer, water bath | DAkkS |
| Relative humidity | 0 up to 95 % r.F. | Dew point mirror, El. humidity sensor | DAkkS |
| Direct voltage Direct current DC Resistance | 0 up to 60 V 0 up to 3 A 0 up to 12 M Ohm | System Multimeter, El. signal meter, Resistance meter, fixed resistor | DAkkS |
The flow quantities at on-site calibrations can now beginning with 16.06.2017 also be certified by a DAkkS calibration certificate.
For the best possible measurement uncertainties (MU) see annex to the DAkkS accreditation certificate or on request. Depending on the on-site calibration conditions in temperature, pressure and humidity though has to be added a MU adder.
Other gases than air on request! In house are more than 12 pure gases and gas mixtures permanently available.
Factory
calibrations for:
– Flow
– Pressure
– Temperature
– Humidity
We are a member of the German Calibration Service
Factory calibrations
for measured variables:
- Flow
- Pressure
- Temperature
- Humidity
Calibrations can also be conducted at your premises!
Downloads and information: